Star-headlight-lantern 7400 Star Lase Manuel d'utilisateur

INSTALLATION AND INSTRUCTION MANUAL PLIT414 REV. E 7/2/13 Ultra Low Profile Modular Lightbar

-7- LED Head programming consist of two options, Phase and Pattern: Phase: Each light head in the Laser lightbar can be set for one of two phases.

-8- (LED Head Programming CONT’D) LED Flash Pattern Selection 1. Connect the red wire to +12VDC, and the black wire to the negative side of the bat

-9- GREEN w/YELLOW: Illuminates all of the front facing heads that have Takedown mode activated into a steady-burn mode. GREEN w/WHITE: Illuminates

-10- You may skip this section if any of the following is true: • Your lightbar is not equipped with a Traffic Director control circuit or • Your l

-11- (TRAFFIC DIRECTOR SETUP CONT’D) Traffic Director Wiring and Programming Internal Traffic Director Controller Wiring If you will be using

-12- (TRAFFIC DIRECTOR SETUP CONT’D) Internal Traffic Director Controller Programming If you will be using an external controller (such as the TD77-

-13- If you are using the TD77-2 controller, you may reference the picture below. TD77-2 Connections (TRAFFIC DIRECTOR SETUP CONT’D) External Tr

-14- Replacement Parts

-15- ROTA TORSSTROB ESLEFTALLEYWORKLIGHTSRIGHTALLE YFLAS HERSSP3860-1SP3860-2 SP3860-3 SP3860-4SB4020SP1515SP3015SB1515SB3015TAKEDOW NGRILLLIGH TSSB40

-16- CAUTION: High voltages can exist in many of our products. Before attempting service on any of our products, be sure to disconnect power for a

-i- It is the sole responsibility of the owner to ensure the lightbar is mounted securely. Check your light every time you enter the vehicle to ens

-17- Determining if the bar is properly grounded: 1. While the bar is turned on, using a test meter, measure the voltage from the base of the bar its

-18- Checking multiple non-working strobe or LED heads: If two or more of the heads connected to the same switch are not flashing, follow these step

-19- If you have any questions concerning this or any other Star product, please contact our Customer Service Department at (585) 226-9787. If a prod

-ii- NOTICE Due to continuous product improvements, we must reserve the right to change any specifications and information, contained

-1- • All standard Laser lightbars have two 15’ harnesses. The first is a 2-conductor (plus a drain wire and a foil shield) “power harness” that has

-2- (Wiring Instructions CONT’D) Wire Connections To aid with installation, the Laser lightbar utilizes two “shielded” wiring harnesses (

-3- (Wire Connections CONT’D) For the RED w/GREEN (Pattern Select) wire, see the LED Flash Pattern Selection section on page 8. For the GREEN w/YELL

-4- Control Wire Colors 1 2 3 4 5 6111213161718a18c9a9cYellow w/Blue StripeYellow w/Purple StripeYellow w/Black StripeYellow w/Orange StripeYellow w/R

-5- Wire Harness Replacement Standard Laser lightbars come with two 15-foot wiring harnesses: a 2-conductor harness for Power and Ground, and a 19

-6- YELLOW/PURPLEBLACK (GROUND)RED (POWER)GREEN/WHITERED/GREENWHITE/ORANGEWHITE/BLUEWHITE/PURPLEWHITE/BLACKWHITE/REDYELLOW/BLUEYELLOW/BLACKYELLOW/ORAN