Star-headlight-lantern STAR-PA RSK966P Manuel d'utilisateur

PLITSTR355 REV. B 9/7/11 INSTALLATION AND INSTRUCTION MANUAL # of Total Joules Model Heads Watts per Side Amps RP966 6 60 20.7J 7.8A

-7- (Electrical Connections CONT’D) 2-Head/4-Head Separate Activation (With High/Low Power Switching Option) or 3-Pair Independent Activation (High Po

-8- (Electrical Connections CONT’D) Two-Head/Four-Head Switching(With High/Low Option) (High Power Only)RP966/RP996 orWith the Jumper in the High /Low

-9- (Electrical Connections CONT’D) Status LED 1. The RP966 and RP996 power packs come with a built-in “star-shaped” status LED. 2. When operating

-10- (Electrical Connections CONT’D) Connecting the Remote Heads: 1. Cable is required to connect the power pack to your remote strobe heads. Cable

-11- Troubleshooting Guide If a problem exists in only one head, a strobe tube may have burned out, or there may be an open electrical connection in t

-12- (Troubleshooting Guide CONT’D) 5. Check each head. If the leads in one of the heads have shorted out, the output voltage of the other heads may

-13- ONE YEAR LIMITED WARRANTY The manufacturer warrants each new product against factory defects in material and workmanship for one year after the d

-i- IMPORTANT: Please read all of the following instructions before installing your new strobe system. Failure to follow these safety precautions m

-ii- Table of Contents NOTICE Due to continuous product improvements, we must reserve the right to change any specifications and inform

-1- Mounting Mount the pack on a smooth metal surface to allow for adequate heat dissipation. Do not mount the pack near any external heat source, as

-2- Red = Enable Heads 5 & 6 Enable Heads 5 & 6 Black = Enable Heads 3 & 4 Enable Heads 1, 2, 3, & 4 White = Enable Hea

-3- (Electrical Connections CONT’D) Setting the High/Low – Head Select Jumper The RP966 and RP996 remote strobe packs allow you to choose whether yo

-4- (Electrical Connections CONT’D) All Heads On and Off Together (High Power Only) (This setup is typically used for most “On/Off” applications) Fo

-5- (Electrical Connections CONT’D) All Heads On and Off Together (With High/Low Power Switching Option) 1. Use Star Model #SP3860-2H-OP switch pane

-6- (Electrical Connections CONT’D) 2-Head/4-Head Separate Activation (High Power Only) (CONT’D) RP966/RP996 Two-Head/Four-Head SwitchingHigh Power On